11.Locate the Cable (35) and note that it has a loop on one end and a ball on the other. Slide the loop through the slot in the Lat Tower (27) from the direction shown.
Place the Cable (35) in the groove of the Pulley (30). Attach the Pulley inside the slot in the Lat Tower (27) with the M10 x 52mm Bolt (38), two M10 Washers (24), two Pulley Spacers (31), and an M10 Nylon Locknut (19).
Press a 38mm Square Inner Cap (21) into the top of the Lat Tower (27).
12.Press a Carriage Bushing (32) onto each end of the Weight Carriage (33).
Press a 25.4mm Round Inner Cap (23) into each end of the welded tube on the Weight Carriage (33).
Insert the M8 x 16mm Bolt (45) into the bracket on the Weight Carriage (33) from the indicated direction.
Note the position of the Lat Tower (27) in step 11. The Lat Tower must be positioned in this manner. Slide the Weight Carriage (33) onto the Lat Tower. Make sure the Weight Carriage is oriented as shown.
13.Secure the looped end of the Cable (35) to the M8 x 16mm Bolt (45) and the bracket on the Weight Carriage (33) with an M8 Nylon Locknut (13).
14.Insert the Lat Tower (27) into the Front Leg (8).
The Lat Tower must be oriented as shown.
Secure the Lat Tower with the Adjustment Knob (39).
Note: The Curl Post (28) and Lat Tower (27) can be interchanged.
15.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in USING THE WEIGHT BENCH, beginning on the follow- ing page.
9
11 |
| 21 |
|
|
38 |
|
|
| |
31 |
|
|
| 35 |
24 |
|
| ||
|
|
| ||
|
|
| 24 | 36 |
| 31 |
| 19 |
|
30 |
| 27 |
| |
|
|
| ||
|
|
|
| |
12 |
|
| 27 |
|
|
|
|
| |
| Bracket | 32 |
| |
|
|
| ||
|
|
| 45 |
|
| 23 |
| 33 |
|
|
|
| 23 |
|
|
| 32 |
|
|
13 |
|
|
|
|
|
| 35 |
|
|
|
|
| 45 |
|
| 13 |
| 33 |
|
|
|
|
| |
14 |
|
|
|
|
|
|
| 27 |
|
| 28 |
|
|
|
|
|
|
| 39 |
|
|
| 8 |
|