Weider 831.159301 user manual Hook Ball

10.Route the Short Cable (58) around the 90mm Pulley (15). Tighten the M10 x 80mm Bolt (16), the M10 Washer (9), and the M10 Nylon Locknut (21).

11.Route the Short Cable (58) under a 90mm Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Front Upright (42) with an M10 x 95mm Bolt (71), an M10 Washer (9), and an M10 Nylon Locknut (21). Make sure that the

Cable Trap is turned to hold the Cable in the groove of the Pulley.

12.Attach the end of the Short Cable (58) to the Long “U”-bracket (57) with an M8 Nylon Locknut

(3) and an M8 Washer (8). See the inset draw- ing. Do not overtighten the Locknut; it should be threaded onto the end of the Cable so that two threads are showing above the nut.

13.Locate the Long Cable (23). Route the Long Cable over a 90mm Pulley (15). Make sure that the Cable is between the Pulley and the hook and that the end of the Cable with the ball is on the indicated side of the hook. Tighten the M10 x 90mm Bolt (85) and the M10 Nylon Locknut (21).

10
	21
	15	58
	17		9
			16
11
			42
		21	9
			58
			15 66	71
12
3	57
8
				3
58
				8
			57	58
13
	21	55
Hook
		15	85
	23
		Ball

9