15.Secure the looped end of the Cable (34) to the M19 x 19mm Bolt (46) in the bracket on the Weight Carriage (32) with an M10 Nylon Locknut (19).
Next, slide the Carriage Stop (39) onto the Lat Tower (26). Make sure the Carriage Stop is turned so that the lip is on top as shown.
Secure the Carriage Stop with an M8 x 70mm Bolt (54) and an M8 Nylon Locknut (13).
16.Insert the Lat Tower (26) into the Lat Tower Base (35). Make sure that the Lat Tower is turned as shown. Secure the Lat Tower with two M10 x 65mm Bolts (18), four M10 Washers (24), and two M10 Nylon Locknuts (19).
17.Attach the Lat Bar (36) to the Cable Clip (33) and place it in the Lat Bar Rest on the Lat Tower (26).
18.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in USING THE WEIGHT BENCH on pages 11 and 12.
10
15 |
|
|
26 | 34 |
|
|
| |
| 19 |
|
46 |
|
|
32 |
|
|
13 |
|
|
| 54 |
|
Lip | 39 |
|
| 26 |
|
|
| 24 |
| 19 | 18 |
|
| 35 |
17 |
|
|
| 33 |
|
36 | 26 |
|