3.Attach the Front Leg (8) to the Frame (2) with two M10 x 65mm Bolts (18), two M10 Washers (24), and two M10 Nylon Locknuts (19).
4.Tap three 45mm Square Inner Caps (21) into the Leg Lever (4) as shown.
Tap a 1Ó Round Inner Cap (23) into the indicated end of the Weight Tube (41).
Insert the Weight Tube (41) into the Leg Lever (4). Press a 1Ó Angle Cap (29) onto the indicated end of the Weight Tube.
5.Lubricate an M10 x 72mm Bolt (40). Attach the Leg Lever (4) to the Front Leg (8) with the Bolt and an M10 Nylon Locknut (19). Do not overtight- en the Nylon Locknut. The Leg Lever must be able to pivot freely.
Attach the Spacer (37) to the Leg Lever (4) with the M8 x 58mm Bolt (39), two M8 Washers (38), and an M8 Nylon Locknut (13). Note: The Spacer will fit tightly inside the Leg Lever.
6.Press four 1Ó Square Inner Caps (12) into the Backrest Tubes (5, 42). Press two 1Ó x 2Ó Inner Caps (36) into the adjustment tubes.
With the wide end of the Backrest (6) positioned as shown, attach the Backrest Tubes (5, 42) to the Backrest with four M6 x 38mm Screws (16) and four M6 Washers (25). Note: The Backrest
Tubes and the Backrest must be oriented exactly as shown.
7
3 |
|
| |
19 |
|
| |
24 |
| 2 | |
|
| ||
18 | 19 |
| |
8 |
|
| |
4 | 21 |
| |
|
| ||
| 4 |
| |
21 |
|
| |
41 |
|
| |
|
| 29 | |
23 | 21 |
| |
|
| ||
5 |
|
| |
19 | 8 |
| |
4 |
|
| |
39 | 40ÐLubricate | ||
38 37 | |||
|
| ||
38 |
|
| |
13 |
|
| |
6 |
|
| |
6 |
| 12 | |
Wide |
| ||
End |
|
| |
5 |
| 25 | |
|
| ||
| 42 | 16 | |
12 | Adjustment | ||
Tubes | |||
25 | |||
16 | 25 |
| |
|
| ||
36 | 16 |
| |