27.Locate the Long Cable (86). Route the Long Cable under the 3 1/2” Low Pulley (88). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame (17) and that the Cable is between the Pulley and the crossbar on the Press Frame. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (not shown).
28.Wrap the Long Cable (86) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the lower hole in the Front Upright (42) with a 3/8” x 3 3/4” Bolt (71), a 3/8” Flat Washer (9), and a 3/8” Nylon Locknut (21). Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown.
27
21
88 Ball
Crossbar 17
86
28
66 21
86
15 |
ASSEMBLY
9
71
42
CABLE
29.Wrap the Long Cable (86) around a 3 1/2” Pulley (15). Attach the Pulley and a Cable Trap (66) to the Press Frame (17) with a 3/8” x 3 1/2” Bolt (16), a 3/8” Flat Washer (9) and a 3/8” Nylon Locknut (21). Be sure that the
Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown.
29
17
86
16
9 15
66
21
30.Wrap the Long Cable (86) around a
(6). Attach the
30 | 85 |
9
6
42
21 86
13