Weider WESY20000 manual Following Tools not Included are Required for Assembly, Locknuts yet

Assembly

Before beginning assembly, carefully read the following information and instructions:

¥Place all parts of the weight system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

¥Read all assembly steps before you begin.

¥For help identifying small parts used in assembly, use the PART IDENTIFICATION CHART on page 5. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

¥Tighten all parts as you assemble them, unless instructed to do otherwise.

¥As you assemble the weight system, make sure that all parts are oriented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

¥Two adjustable wrenches

¥One phillips screwdriver

¥One rubber mallet

¥Lubricant, such as grease or petroleum jelly, and soapy water are also needed.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Press a 51mm Round Outer Cap (20) onto each end of the Front Stabilizer (6). Make sure the welded bolts are facing up.

With the help of another person, pivot the Upper Frame (1) so that it aligns with the Lower Frame (2) as shown. Secure the Upper and Lower Frames in place by tightening the two M10 x 36mm Button Head Bolts (45) and M10 Nylon Locknuts (42).

Place the Frame (1, 2) on the welded bolts on the Front Stabilizer (6).

2.While another person holds the Upper Frame (2) upright, place the Base (7) on the welded bolts on the Front Stabilizer (6). Attach the Base and the Frame (1, 2) to the Front Stabilizer using two M10 Nylon Locknuts (42). Do not tighten the Nylon

Locknuts yet.

1	45	1
	42	45
		2
	20
		Welded Bolts
		6
			20
2
		1
		2	7
		42
		6

6