7.With the Seat (12) oriented as shown, attach the Seat to the Seat Carriage (11) using four M6 x 16mm Screws (31).
8.Slide the Seat (12) onto the Rail (8). Make sure the
Seat is oriented as shown, with the pop pin on the indicated side.
9.Press a 50mm Square Inner Cap (47) into the top of the Rail Leg (9). Press the Rail Leg Cap (34) onto the bottom of the Rail Leg. Attach the Bumper (25) to the Rail Leg using an M4 x 16mm Screw (26).
Using the Union Bolt Set (61), attach the Rail Leg
(9)to the Rail (8). Do not overtighten the Union Bolt Set. The Rail Leg must be able to pivot freely for storage.
Slide the Short Lock Pin (21) into the other hole in the Rail (8) and the Rail Leg (9). Press the Lock
Pin all the way through the Rail and the Rail Leg.
10.Press a 45mm Square Inner Cap (29) into each end of the Leg Lever (10).
Slide the Short Cable (19) through the indicated hole in the Rail Leg (9). Attach the Short Cable to the Leg Lever (10) using an M10 x 60mm Bolt (38), two M10 Flat Washers (44), two 21mm Spacers (41), and an M10 Nylon Locknut (42).
8
7 | 12 |
|
|
| |
Wide End |
| |
| 11 |
|
|
| 31 |
8 |
|
|
|
| 8 |
| 12 |
|
|
| Pop Pin |
9 |
| 8 |
| 61 | |
|
| |
| 47 |
|
25 |
| 61 |
|
| |
26 |
|
|
| 9 | 21 |
| 34 |
|
10 |
|
|
29 |
|
|
| 9 |
|
42 | 10 |
|
|
| |
44 |
| 19 |
|
| |
41 | 38 |
|
|
| |
29 | 44 |
|