Weider WESY19510 user manual Inset shows view

Page 12

22.Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the upper hole in the Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (71).

23.Attach the end of the Short Cable (58) to the Long “U”-Bracket (57) with a 1/4” Nylon Locknut

(2) and a 1/4” Flat Washer (10). See the inset drawing. Do not overtighten the Nylon Locknut; it should be threaded onto the end of the Cable so only a couple of threads are showing above the nut.

22	42
	15
	71
	66
	58
	Inset shows view
	from other side
	58
42	15
21
23
	2
	57
	10
	58
	2
	10
57	58

12

Image 12

Contents QUESTIONS? Model No. WESY19510 Serial NoTable of Contents Important Precautions Decal Decal. Apply the decal in the location shownBefore YOU Begin Assembly Frame AssemblyMake Things Easier for Yourself Weights Locknuts yetTighten the Nylon Locknuts used in steps Arm Assembly Weight Guides are at the top, as shownLocknut the Press Frame must be able to pivot freely Arm. Arm identification is very important for Step Sure that the upper end of the Right Arm isBehind the indicated bracket on the Top Frame Cable Assembly Page Locate the Short Cable 58. Lay the Short Inset shows viewFrom other side Inset shows view Seat Assembly Page Page Adjustments Changing the Weight SettingAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart TROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagram Long Cable 23 TOP ViewShort Cable Page Part LIST-Model No. WESY19510 Key No. Qty DescriptionExploded DRAWING-Model No. WESY19510 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19510 R1101A