Weider WESY19510 user manual Arm Assembly, Weight Guides are at the top, as shown

Page 7

5.Press the Weight Tube Bumper (64) into the end of the Weight Tube (63). Insert the Weight Tube into the stack of Weights (25). Be sure that the pins on the Weight Tube are resting in the pin grooves in the upper Weight.

Lubricate the insides of the holes in the Top Weight (76). Set the Top Weight onto the stack of Weights (25).

Insert both Weight Guides (62) into the stack of Weights (25). Be sure that the holes in the

Weight Guides are at the top, as shown.

6.Attach the upper ends of the Weight Guides (62) to the Top Frame (55) with the 5/16” x 6” Bolt (60), two 1/2” x 3/4” Spacers (61), and a 5/16” Nylon Locknut (3).

Be sure that the Pulley Bracket (20) is in front of the right Weight Guide (62) as shown.

Arm Assembly

7.Press a 1” x 7/8” Plastic Bushing (75) onto each welded spacer on the Press Frame (17). Slide the Press Frame into place on the Base (4). Note:

This will be a tight fit. The Plastic Bushings should fit onto each end of the indicated tube in the Base. Be sure that the 3 1/2” Pulley (15) is on the indicated side.

Lubricate the 3/8” x 8” Bolt (59). Attach the Press Frame (17) to the Base (4) with the Bolt and a 3/8” Nylon Locknut (21). Do not overtighten the

Locknut; the Press Frame must be able to pivot freely.

5

 

 

 

 

Holes

 

 

62

 

76

 

 

 

Lubricate

 

 

63

 

 

64

 

Pin Groove

 

 

25

 

6

61

 

 

3

 

 

 

 

55

 

60

20

 

 

62

7

 

 

 

 

15

 

 

17

 

 

Lubricate

 

21

59

 

4

Welded

 

 

 

Tube

Spacers

 

 

75

7

Image 7
Contents Model No. WESY19510 Serial No QUESTIONS?Table of Contents Decal Decal. Apply the decal in the location shown Important PrecautionsBefore YOU Begin Frame Assembly AssemblyMake Things Easier for Yourself Locknuts yet WeightsTighten the Nylon Locknuts used in steps Weight Guides are at the top, as shown Arm AssemblyLocknut the Press Frame must be able to pivot freely Sure that the upper end of the Right Arm is Arm. Arm identification is very important for StepBehind the indicated bracket on the Top Frame Cable Assembly Page Inset shows view Locate the Short Cable 58. Lay the ShortFrom other side Inset shows view Seat Assembly Page Page Changing the Weight Setting AdjustmentsAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart Tightening the Cables TROUBLE-SHOOTING and MaintenanceLong Cable 23 TOP View Cable DiagramShort Cable Page Key No. Qty Description Part LIST-Model No. WESY19510Exploded DRAWING-Model No. WESY19510 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19510 R1101A