Weider WESY19510 user manual Cable Assembly

Page 9

Cable Assembly

11.During steps 11 through 24, refer to the CABLE DIAGRAM on page 20 of this manual to verify proper cable routing. Before beginning this sec- tion, identify the Long Cable (23) and the Short Cable (58) by comparing the lengths of the cables.

IMPORTANT: While assembling the cables, do not overtighten the bolts and nuts securing the pulleys. The pulleys must be able to turn freely.

12.Locate the Long Cable (23). Route the Long Cable around the indicated 3 1/2” Pulley (15) attached to the Top Frame (55). Be sure that the

Cable is between the Pulley and the hook and that the end of the Cable with the ball is on the indicated side of the hook. Tighten the 3/8” x 3 3/4” Bolt (71) and the 3/8” Nylon Locknut (not shown).

13.Wrap the Long Cable (23) around a “V”-Pulley

(6).Attach the “V”-Pulley and a Long Cable Trap

(50)to the indicated bracket on the Front Upright

(42)with a 3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut (21). Be sure that the Long Cable Trap is positioned to hold the Cable in place.

14.Route the Long Cable (23) around the “V”-Pulley

(6) on the Left Arm (47). Be sure that the Cable is in the groove of the Pulley and that the Long Cable Trap (50) is positioned to hold the Cable in place. Tighten the 3/8” x 2 1/2” Bolt (7) and the 3/8” Nylon Locknut (not shown).

9

11

 

 

 

 

23

 

 

58

 

 

 

12

 

 

23

 

 

 

 

55

 

 

 

Ball

 

 

 

15

 

 

71

 

 

 

Hook

 

 

13

 

7

 

 

 

 

 

 

6

50

 

 

 

 

 

42

 

 

 

 

23

 

21

 

 

14

 

 

50

 

 

7

 

6

 

 

 

 

 

 

47

 

 

23

 

 

Image 9
Contents Model No. WESY19510 Serial No QUESTIONS?Table of Contents Decal Decal. Apply the decal in the location shown Important PrecautionsBefore YOU Begin Assembly Frame AssemblyMake Things Easier for Yourself Weights Locknuts yetTighten the Nylon Locknuts used in steps Arm Assembly Weight Guides are at the top, as shownLocknut the Press Frame must be able to pivot freely Arm. Arm identification is very important for Step Sure that the upper end of the Right Arm isBehind the indicated bracket on the Top Frame Cable Assembly Page Locate the Short Cable 58. Lay the Short Inset shows viewFrom other side Inset shows view Seat Assembly Page Page Changing the Weight Setting AdjustmentsAttaching the LEG Lever to the LOW Pulley Station Weight Resistance Chart Tightening the Cables TROUBLE-SHOOTING and MaintenanceCable Diagram Long Cable 23 TOP ViewShort Cable Page Key No. Qty Description Part LIST-Model No. WESY19510Exploded DRAWING-Model No. WESY19510 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Part Identification Chart from the Manual Part Identification CHART-Model No. WESY19510 R1101A