26.Press a 1 1/2” Square Inner Cap (32) into the Seat Frame (36).
Insert the 1/4” x 2” Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4” x 3/4” Screws
Insert the 1/4” x 2” Carriage Bolt (38) into the indi- cated hole in the Seat Frame (36). Tighten a 1/4” Nylon Locknut (2) with a 1/4” Flat Washer (10) onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4” Flat Washer (10) and the 1/4” x 2” Screw (24).
27.Press a 1 1/2” Square Inner Cap (32) into the Leg Lever (29).
Lubricate the 5/16” x 2 3/4” Bolt (11). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16” Nylon Locknut (3). Do not over- tighten the Nylon Locknut; the Leg Lever must be able to pivot freely.
Insert two 3/8” x 2” Eyebolts (35) into the Leg Lever (29) from the directions shown. Tighten a 3/8” Nylon Locknut (73) and a 3/8” Flat Washer
(9)onto each Eyebolt.
28.Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16” x 2 3/4” Carriage Bolt (14) and the Seat Knob (40).
14
26 |
|
|
|
| 13 |
| 38 |
|
| 37 | 32 |
|
| |
|
| 18 |
36 |
|
|
24 | 10 |
|
| 2 | |
|
| |
27 |
|
|
|
| 36 |
2 |
| 3 |
|
| |
Lubricate |
| |
| 11 | 29 |
|
| |
| 35 | 9 |
| 73 | 73 |
| 9 |
|
| 32 |
|
|
| 35 |
28 |
|
|
| 40 |
|
| 36 |
|
14 |
|
|
Pin |
|
|
42 |
|
|