Weider WESY19001 user manual Locknut. The Pulley must be able to turn freely, Nylon Locknut yet

CABLE ASSEMBLY

23.Important: As you assemble the Long Cable (69) in steps 23–30, refer to the Cable Diagram on page 21.

Route the Long Cable (69) between the Base

(4)and the Press Frame (17) as shown. Lay the Long Cable in the bracket on the Base.

Attach the Pro-Pulley (77) to the bracket using a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Do not overtighten the Nylon

Locknut. The Pulley must be able to turn freely.

24.Hold the Long Cable (69) against a 3 1/2” Pulley (15). Hold a Cable Trap (66) against the Pulley to hold the Cable in place.

Attach the 3 1/2” Pulley (15) and the Cable Trap (66) to the Front Upright (42) using a 3/8” x 4 1/4” Bolt (64), a 3/8” Flat Washer (9), and a 3/8” Nylon Locknut (21). Do not over- tighten the Nylon Locknut. The Pulley must be able to turn freely.

25.Remove the pre-assembled 3 1/2” Pulleys (15) from the Pulley Plates (58). Route the Short Cable (23) around one of the Pulleys. Reattach a Pulley Plate to each side of the Pulley with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Do not tighten the

Nylon Locknut yet.

Route the Long Cable (69) around the other 3 1/2” Pulley (15). Attach the Pulley to the bottom set of holes in the Pulley Plates (58) with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Do not overtighten the Nylon

Locknuts; the Pulleys must be able to turn freely.

26.Route the Long Cable (69) around a 3 1/2” Pulley (15) as shown. Hold a Cable Trap (66) against the Pulley so that the Cable is held securely in the groove.

Attach the 3 1/2” Pulley (15) and the Cable Trap (66) to the Front Upright (42) using a 3/8” x 4 1/4” Bolt (64), a 3/8” Flat Washer (9), and a 3/8” Nylon Locknut (21). Do not over- tighten the Nylon Locknut. The Pulley must be able to turn freely.

23
	17
		77
			12
			69
	21
	Bracket		4
24
		64
9		15
21	42	69
	66
25
		23
	21	15
		58
	58		12
		69
26		42
		9	21
	66
			69
64	15

14