Weider WESY19001 user manual Adjustment, Changing the Weight Setting

Page 18

ADJUSTMENT

The instructions below describe how each part of the training system can be adjusted. Refer to the exercise guide accompanying this manual to see how the training system should be used for each exercise. IMPOR-

TANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct start- ing position for the exercise to be performed. If there is any slack in the cables or chain as an exercise is performed, the effectiveness of the exercise will be reduced.

CHANGING THE WEIGHT SETTING

To change the weight setting of the weight stack, insert the Weight Pin (26) under the desired Weight (25). Be sure to insert the Weight Pin until the bent end of the Weight Pin is touching the Weights, and turn the bent end downward. The weight setting of the weight stack can be changed from 6.5 pounds to 86.5 pounds, in increments of 10 pounds. Note: Due to the cables and pulleys, the actual amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 19 to find the actual amount of resistance at each weight station.

ATTACHING THE LAT BAR OR NYLON STRAP TO THE HIGH PULLEY STATION OR THE LOW PUL- LEY STATION

Attach the Lat Bar (54) to the Short Cable (23) or the Long Cable (69, not shown) with a Cable Clip (53). For some exercises, the Chain (52) should be attached between the Lat Bar and the Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) can be attached in the same manner.

ATTACHING AND REMOVING THE CURL PAD

For some exercises, the Curl Pad (24) must be attached to the training system. Remove the 1 1/2” Square Inner Cap (32) from the Seat Frame (36). Insert the Curl Post (35) into the Seat Frame, and tighten the Knob (51) into the Seat Frame and the Curl Post.

To remove the Curl Post (35) from the Seat Frame (36), first remove the Knob (51). Lift the Curl Post off the Seat Frame and insert the 1 1/2” Square Inner Cap (32).

26

 

25

 

53

 

52

 

23

 

54

39

 

24

32

 

36

 

51

35

 

18

Image 18
Contents QUESTIONS? Model No. WESY19001 Serial NoTable of Contents Important Precautions Before YOU Begin Part Identification Chart Page Assembly Make Assembly Easier for YourselfFrame Assembly Base is oriented exactly as shownNylon Locknuts yet Locknuts yet Frame Assembly ARM Assembly Tighten all Nylon Locknuts used in steps 3 throughARM Assembly Overtighten the Nylon Locknut. The Pulley ARM Assembly Cable AssemblyIndicated bracket on the Top Frame Must be able to turn freelyLocknut. The Pulley Bracket must be able to pivot freely Locknut. The Pulley must be able to turn freely Nylon Locknut yetLocknuts the Pulleys must be able to turn freely Cable Assembly Seat Assembly TROUBLE-SHOOTING and Maintenance on Adjustment Changing the Weight SettingWeight Resistance Chart TROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagram Part LIST-Model No. WESY19001 Key No. Qty DescriptionR0201A Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT