Weider WEBE27320 user manual Locknuts 32. Do not tighten the Locknuts yet

17. Press a 51mm x 76mm Inner Cap (21) into the	17
top of a Front Upright (44). Attach an Upright
				21
Cover (51) to the Front Upright with five M4 x
			51
16mm Screws (63).
Attach the Front Upright (44) to a Base (42) with			63
four M10 x 94mm Bolts (18), two Small Joint
Plates (40), and four M10 Nylon Locknuts (32).
Do not tighten the Locknuts yet.			63
Repeat this step with the other Front Upright				44
(44) and the other Base (42).			63
			63
			63
		32	40
			32	40
				18
			42
				18
18. Attach the Left Rear Upright (46) to the left Front	18
Upright (44) with four M10 x 94mm Bolts (18),
	32		40	46
two Small Joint Plates (40), and four M10 Nylon
Locknuts (32). Do not tighten the Locknuts yet.
Repeat this step with the Right Rear Upright (not				40
shown).
			44
				18
19. Press two 51mm Round Inner Caps (23) into the	19
ends of the two Carriage Tubes (69). Screw the
			23
Carriage Tubes onto the Weight Carriage (50) as
shown. Make sure the Carriage Tubes are fully			69
tightened.
			50	69
				23
	11