Weider WEBE27320 user manual Locknut the Leg Lever must be able to pivot easily

9.Press three 50mm Square Inner Caps (22) into the Leg Lever (7). Press a 51mm Round Inner Cap (23) into the tube on the Leg Lever.

Slide the two Pad Tubes (16) into the Leg Lever

(7). Slide four Foam Pads (17) onto the ends of the Pad Tubes. Press four 19mm Round Inner Caps (19) into the ends of the Pad Tubes.

10.Press two Bushings (34) into the Leg Lever Bracket (8) as shown.

Attach the Leg Lever (7) to the Leg Lever Bracket

(8)with an M10 x 78mm Bolt (75) and an M10 Nylon Locknut (32). Do not overtighten the

Locknut; the Leg Lever must be able to pivot easily.

Loosen the Seat Knob (24). Secure the Leg Lever Bracket (8) in the end of the Seat Frame (5) with the Knob.

11.Press a 45mm Square Inner Cap (76) into the bottom of the Curl Post (12).

Attach the Curl Pad (13) to the Curl Post (12) with two M6 x 16mm Screws (31).

9			22
	17
	7
				19
22	17				16
					19
					17
	23	22	19	16
					19
					17
10
		32		8	5
	7				24
			34	75
11
				13
			12
					31
			76

8