Weider WEBE27320 user manual Tighten all of the M10 Nylon Locknuts Used in steps

24. Route the Cable (79) through the Lat Tower Base	24
(49) and around an 89mm Pulley (65). Attach the
		32 65
Pulley to the bracket on the Lat Tower Base with
an M10 x 45mm Bolt (27) and an M10 Nylon		27
Locknut (32).
	79
		49
25. Route the Cable (79) under an 89mm Pulley (65)	25
and through the Foot Plate (57) as shown. Attach		74
	43
the Pulley to the Foot Plate with an M10 x 45mm		32
Bolt (27) and an M10 Nylon Locknut (32).		74
	27
Attach the Foot Plate (57) to the Lat Tower Base		32
(49) with two M10 x 19mm Bolts (72) and two		65
		32
M10 Nylon Locknuts (32).
		32
Attach the Foot Plate (57) to the Front Crossbar	18
(43) with two M10 x 94mm Bolts (18), two M10		32
	79
Washers (74), and two M10 Nylon Locknuts (32).		49
Tighten all of the M10 Nylon Locknuts (32)	72
used in steps 12–18.		57
26. Press two 51mm Round Inner Caps (23) into two	26
Storage Tubes (70). Screw the Storage Tubes
onto the Left Rear Upright (46). Make sure the
Storage Tubes are fully tightened.		70
Repeat this step with the other two Storage		23
		46
Tubes (70) and the Right Rear Upright (not
shown).		70
		23
27. Press a 38mm Round Inner Cap (68) into the end	27
of the Left Weight Rest (80). Press a 38mm
Round Inner Cap into the Left Safety Spotter (81).		68
	80
Insert the Left Weight Rest (80) and the Left
Safety Spotter (81) into holes in the left Front		44
Upright (44) and engage the locking pins around
	81	68
the Upright.
Repeat this step with the Right Weight Rest
(not shown), the Right Safety Spotter (not
shown), and the right Front Upright (not
shown).
	13