USING THE LEG LEVER LOCK
When using the low pulley station, engage the Leg Lever Lock (47) onto the Leg Lever (15) tube.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the weight pin into the middle of the weight stack. Slack can be removed from these cables in several ways:
See drawing A. Remove the M10 Nylon Locknut (84) and the M10 x 50mm Bolt (105) from the indicated Pulley (43), Cable Trap (48), Half Guards (46), and Pulley Plates (49). Reattach the Pulley, Cable Trap, and Half Guards using a hole closer to the center of the Pulley Plates. Make sure that the Cable Trap is oriented to hold the cable in the groove of the Pulley, that the Half Guards are oriented as shown, and that the Cable and Pulley move smoothly. Adjust the top Pulley (43) in the same manner, if necessary.
See drawing B. To remove slack from the Press Cable (72), tighten the M6 Nylon Locknut (103) fur- ther onto the end of the Press Cable (72).
| 47 | |
| 15 | |
A |
| |
43 |
| |
84 | 49 | |
46 | 46 | |
105 | ||
48 | ||
| ||
| 43 | |
B |
| |
| 43 | |
50 | 103 | |
| ||
72 |
|
27