Weider WESY3906.0 user manual Cable Trap is oriented to hold the Cable

47. Wrap the Press Cable (72) under a Pulley (43).	47
Attach the Pulley, a Cable Trap (48), an M10
		43 48
Washer (108), and two Half Guards (46) to the				97
Left Seat Upright (14) with an M10 x 120mm Bolt	46 108			46
(97) and an M10 Nylon Locknut (84). Make sure	14
that the Cable Trap is oriented to hold the			72
Cable in the groove of the Pulley. Make sure
the Half Guards are oriented as shown.
	84
48. Note: This step is shown from the opposite	48			13
side of the Press Frame (13).
Wrap the Press Cable (72) under a Pulley (43).
Attach the Pulley, a Cable Trap (48), an M10	108			84
Washer (108), and two Half Guards (46) to the
Press Frame (13) with an M10 x 45mm Bolt (95)	48
			46
and an M10 Nylon Locknut (84). Make sure that	46
the Cable Trap is oriented to hold the Cable in	95		72
the groove of the Pulley. Make sure the Half	43
Guards are oriented as shown.
49. Wrap the Press Cable (72) under a Pulley (43).	49
Attach the Pulley, a Cable Trap (48), an M10
Washer (108), and two Half Guards (46) to the
Left Base (2) with an M10 x 130mm Bolt (106)
and an M10 Nylon Locknut (84). Make sure that
the Cable Trap is oriented to hold the Cable in		46	106
the groove of the Pulley. Make sure the Half	72
Guards are oriented as shown.	43	48
	46
		108
	84	2
50. Attach the Press Cable (72) to the Small Pulley	50
Plate (50) with an M6 Washer (90) and an M6
Nylon Locknut (103). See the inset drawing. Do
not completely tighten the Nylon Locknut; it
should be tightened so that only two threads
of the Cable show past the Nylon Locknut.
		103
		90
	50			50
	72			103
				72
	21