Weider WESY3906.0 user manual Arm Assembly, Nylon Locknuts 84. Do not tighten the Bolts Yet

13. Slide eleven 12.5-lb. Weights (34), with the pin	13
grooves on the bottom, onto the Weight Guides
(30).
Orient a Weight Tube (75) as shown. Insert the		34
Weight Tube into the stack of Weights (34).
Slide another 12.5-lb. Weight (34) onto the		30
Weight Guides (30).
				30
		75
		34
		Pin
		Groove
14. Attach the Center Top Frame (6) to the Right and	14		108
Left Top Frames (3, 4) with four M10 x 70mm		84		84
Bolts (57), four M10 Washers (108), and two M10
Nylon Locknuts (84). Do not tighten the Bolts
yet.		6
Attach a Weight Guide (30) inside the Center Top		68		68
		87	108
				87
Frame (6) with an M10 x 65mm Bolt (87), two	57				57
M10 Washers (108), a 1/2” Bushing (68), and an		108
M10 Nylon Locknut (84).					108
	3
Attach the other Weight Guide (30) to the					4
Center Top Frame (6) in the same manner.
Tighten the bolts, screws and locknuts used		30		30
in steps 3, 4, 7, 9, 10, 11, and 14.
Arm Assembly	15
		86			86
15. Apply grease to a 2" Bushing (63) and insert the			63
Bushing into the Leg Lever (15). Attach the Leg				10
		15
Lever and the Bushing to the Curl Post Upright
			Grease
(10) with a 2 1/4" Bolt Set (86).

12