Weider WESY38320 user manual Trap is turned to hold the Cable in the groove of the Pulley

Page 13

24.Route the Lat Cable (88) over a 3 1/2” Pulley (78). Slide a Long Cable Trap (102) onto a 3/8” x 1 3/4” Bolt (93). Attach the Pulley to the indicated bracket on the Top Frame (6) with the Bolt and a 3/8” Nylon Locknut (87). Make sure that the Long Cable

Trap is turned to hold the Cable in the groove of the Pulley.

25.Remove the preassembled 3/8” Nylon Locknut (87) and 3/8” x 2” Bolt (100) from the Pulley Plates (63).

Wrap the Lat Cable (88) under a 3 1/2” Pulley (78). Attach the Pulley and a Cable Trap (68) between the indicated holes in the Pulley Plates (63) with the 3/8” x 2” Bolt (100) and the 3/8” Nylon Locknut (87).

Make sure that the Cable Trap is turned to hold the Cable in place.

26.Attach the end of the Lat Cable (88) inside of the Butterfly Top Frame (7) with a 5/16” x 2 1/2” Bolt (59), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86).

27.Locate the Butterfly Cable (69), which is the shortest Cable. Attach the Cable to the Pivot Bracket (70) on the Left Butterfly Arm (25) with a 5/16” x 1” Shoulder Bolt (103) and a 5/16” Nylon Locknut (86).

13

24				88
	6		78	88
	6	87
		87
				102
				93
25
		100 88
				78
				87
		68
		63
			63
26	86		90
			7	90
			7	59
				59
		88
27
		86	69
				103
			70
			25

Image 13

Contents Model No. WESY38320 Serial No QUESTIONS?Customer HOT Line Table of Contents Decal Important PrecautionsDecal Before YOU BeginOne on each side Assembly Not tighten the Nylon Locknuts yet Frame AssemblyDo not tighten the Nylon Locknuts yet Locknuts yetTighten all of the 5/16 Nylon Locknuts 86 used in this step Assemble the other weight stack in the same way Repeat this step with the Left Butterfly Arm Open the parts bag labeled ARM AssemblyRepeat this step with the Right VKR Arm Cable Assembly119 Trap is turned to hold the Cable in the groove of the Pulley Page Page Page Page Page Locate and open the parts bag labeled Seat Assembly Seat AssemblyRepeat this step with the other end of the Squat Arm Tighten all of the 3/8 Nylon Locknuts 87 used in this step Changing the Weight Setting AdjustmentsConverting the Butterfly Arms Ing any exerciseAdjusting the Squat Knee Rest Adjusting the Squat ARM, SEAT, or Butterfly BackrestAdjusting the Curl PAD Plates Weight Resistance ChartTightening the Cables TroubleshootingLat Cable Cable DiagramsButterfly Cable Squat Cable VKR High VKR Low Leg LeverR1102A Part Identification CHART-Model No. WESY38320X 3 1/4 Bolt Page Key Qty Description Part LIST-Model No. WESY38320Exploded DRAWING-Model No. WESY38320 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT