20.Remove the preattached 3 1/2” Pulleys (78 [only one is shown]) from the Offset Double “U”- bracket (61).
Wrap the VKR High Cable (74) under a 3 1/2” Pulley (78). Attach the Pulley to the Offset Double
21.Wrap the VKR High Cable (74) over a 4 1/2” Pulley
(119).Attach the Pulley inside of the indicated bracket on the Top Frame (6) with 3/8” x 1 3/4” Bolt
(93)and a 3/8” Nylon Locknut (87).
22.Place a 1/2” Washer (1) on top of the Weight Tube (43) closest to the VKR Upright (5).
Tighten a 1/2” Nut (118) halfway onto the end of the VKR High Cable (74). Screw the end of the Cable two full turns into the Weight Tube (43). Then, tighten the Nut against the 1/2” Washer (1).
23.Locate the Lat Cable (88), which is 89 1/4” long and has an eyelet on one end and a ball on the other end. Route the eyelet end of the Cable up through the Butterfly Top Frame (7) and around a 3 1/2” Pulley (78). Attach the Pulley inside of the Butterfly Top Frame with a 3/8” x 2 3/4” Bolt (101), two 3/8” Washers (91), two 1/2” Spacers (89), and a 3/8” Nylon Locknut (87).
12
20 |
|
| 74 |
78 | 93 |
| 87 |
| 61 |
21 | 6 |
| |
| 87 |
93 |
|
| 119 |
| 74 |
22 |
|
5 |
|
| 74 |
| 118 |
43 | 1 |
| |
23 |
|
| 7 |
78 |
|
87 |
|
91 |
|
89 | 91 |
| 101 |
88 |
|