Weider WESY38320 instruction

36.Remove the preattached 3 1/2” Pulley (not shown) from the “U”-bracket (64).

Attach the end of the Leg Lever Cable (75) to the “U”-bracket (64) with a 1/4” Washer (97) and a 1/4” Nylon Locknut (34). Note: Do not completely tighten the Nylon Locknut; it should be thread- ed only two turns onto the end of the Cable.

37.Locate the VKR Low Cable (72), which is the only remaining cable that has an eyelet on one end and a ball on the other end. Route the eyelet end of the Cable through the cage on the Long Base (120) and through the VKR Upright (5) as shown.

Attach a 3 1/2” Pulley (78) to the indicated bracket on the Long Base (120) with 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

38.Wrap the VKR Low Cable (72) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated brack- et on the Long Base (120) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

39.Wrap the VKR Low Cable (72) over a 3 1/2” Pulley (78). Attach the Pulley to the Offset Double “U”- bracket (61) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

36
75
64
97
34
37
78
5
87
72
93
120
38
87
78
72
93
120
39
93
87
61
72
78