48.Wrap the Squat Cable (73) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated bracket on the Long Base (120) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
49.Wrap the Squat Cable (73) over a 4 1/2” Pulley (119). Attach the Pulley to the indicated bracket on the Top Frame (6) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
50.Place a 1/2” Washer (1) on top of the Weight Tube (43) closest to the Squat Upright (4).
Tighten a 1/2” Nut (118) halfway onto the end of the Squat Cable (73). Screw the end of the Cable two full turns into the Weight Tube (43). Then, tighten the Nut against the 1/2” Washer (1).
SEAT ASSEMBLY
51.Locate and open the parts bag labeled “SEAT ASSEMBLY.”
Insert the Pad Tube (23) into the square hole in the Seat Upright (9). Slide the two Knee Pads (19) onto the Pad Tube as shown. Press the two Knee Pad Caps (109) into the ends of the Pad Tube.
Slide two Short Pads (20) onto the Leg Lever (10).
48 |
|
|
|
|
|
| 78 |
| 73 |
| 87 |
|
|
| |
| 93 | 120 |
|
|
|
| |
49 |
| 6 | 87 |
|
| ||
| 93 |
|
|
|
|
| 119 |
|
|
| 73 |
50 |
|
|
|
|
|
| 4 |
|
| 73 |
|
|
| 118 |
|
|
| 1 |
|
|
| 43 |
|
51 | 19 |
|
|
|
|
| |
109 | 23 |
|
|
|
|
| |
|
| 9 | 19 |
| 20 |
| 109 |
| 10 | ||
|
| ||
|
| 20 | |
19