32.Locate the Leg Lever Cable (75), which is 88” long and has an eyelet on one end and a thread- ed pin on the other end. Route the eyelet end of the Cable through the Seat Upright (9) and attach it to the tab on the Leg Lever (10) with a 5/16” x 1” Shoulder Bolt (103) and a 5/16” Nylon Locknut (86).
33.Attach a 3 1/2” Pulley (78) inside of the Seat Upright (9) with a 3/8” x 2 3/4” Bolt (101), two 3/8” Washers (91), two 1/2” Spacers (89), and a 3/8” Nylon Locknut (87) as shown.
34.Route the Leg Lever Cable (75) under a 4 1/2” Pulley (119). Attach the Pulley and a Large Cable Trap (121) to the indicated side of the Butterfly Upright (3) with a 3/8” x 3 3/4” Bolt (122), a 3/8” Washer (91), and a 3/8” Nylon Jamnut (113). Make sure that the Large Cable Trap is turned to hold the Cable in the groove of the Pulley.
35.Wrap the Leg Lever Cable (75) over a 3 1/2” Pulley
(78).Attach the Pulley to the Double
(62)with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
15
32 |
|
|
| 10 |
|
86 |
| 75 |
| 9 | |
|
| |
| Tab | 103 |
|
| |
33 |
|
|
| 9 |
|
87 | 89 | 78 |
|
| |
91 |
|
|
|
| 75 |
|
| 89 |
|
| 101 |
|
| 91 |
34 |
|
|
| 122 |
|
| 121 |
|
| 119 |
|
|
| 91 |
| 75 | 113 |
|
| |
|
| 3 |
35 |
| 93 |
|
| |
| 87 | 62 |
|
| |
|
| 75 |
|
| 78 |