Haier HWM70-918NZP user manual Trouble-shooting Answer to question

Trouble-shooting Answer to question

(If there’s breakdown, please pull off the power plug before checking)

The following phenomenon are not breakdowns sometimes. Please confirm again before sending it to repair.

If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

Phenomena		The reason	How to settle
The digitron displays E0.		The top lid is open during	 Close the top lid.
		reserve procedure.
The drainage cannot		Is the drain hose put down?	 Put down the drain hose. Open and
work, or is too slow. The		Is the drain hose blocked?		close the top lid once.
digitron displays E1.				Clean the foreign material. Open and
				close the top lid once.
It stops running in		The top lid is not closed.	 Close the top lid.
midway. The digitron
displays E2.
The safety switch acts,		Are the laundries put slantingly?	 Reorder the laundries. Close the top lid.
and the spinning cannot		Is the machine slanting?	 Place the machine horizontally, open
work. The digitron				and close the top lid once.
displays E3.
The water filling does		Is the water tap opened, or is	 Open the water tap. Open and close the
not work, or is slow, the		there water supply failure?		top lid once.
digitron displays E4.		Is the water inlet valve blocked?	 Clean the water inlet valve then open
		Is the water pressure too low?		and close the top lid once.
			 Use after the water pressure is normal.
The digitron displays E6.		The water level sensor is bad.	 Please contact the after-sales service
				department.
The	Not wash	Is there power failure?	 Please use it when there’s power
machine		Is the power plug inserted tightly?		supply.
does not		Is the water level reached preset	 Insert the power plug tightly.
act		position?	 Fill water to the preset position.
	Not spin	Is the power plug inserted tightly?	 Insert the power plug tightly.
		Is the top lid closed reliably?	 Close the top lid.
		Are the laundries set flat?	 Set the laundries flat.
There is abnormal sound		Is the machine slanting?	 Adjust the machine to be even
		Are the laundries put slantingly in
inside the machine			 Reorder the laundries and close the top
		spinning?
				lid.
		Are there any foreign materials?
			 Remove the foreign materials.
The water tap leaks		Is the screw of the jointer of water	 Fasten the screw of the jointer properly.
		inlet hose loose or awry?

15