Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
1.Move the control handle of trundle to the point 1 and the control handle fix on the second reference column; Then insert the base panel from the side and fix it in
the suitable site which aim to the hool of bolt.
The control handle of trundle The frist reference colunm
The second | Pullback spring |
| |
reference colunm |
|
2.Caste hit the control handle position shown in the figure ,the control handle will be fixed by the frist reference columns to install the screw into the bottom of the washing machine with
a screwdriver,then gently propped.
Adjustable foot
Front
Screw
Bottom plate Carpet | The operation of trundle |
Back |
Carpet |
Figure 1 | Figure 2 |
The washing machine away from wall should be overrun 20mm. The largest allowable slope of the shank base of the machine is 2°. The slanting or rough ground will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is horizontal.
Adjust the adjustable foot:
1.To twist the adjustable foot, please first lift up the side of the leg slightly, loosen the adjustable nut, and twist the foot. Please make sure to keep the washing machine in balance.
2.After adjustment, fasten the nut.
The adjustable foot
5