Problem

=*ldno

slow drying

CHECK IF

Items are oven&fed

Fabric type and quality is suitable for dryiig

There is a large amount of moisture in the load to be dried

Cold rinse water ia used

Room air tempemture is below 45°F (7%)

Dryer is exhausted according to Installation lnstructlons

Lint screen is full

Exhaust duct or outside exhaust hood is clogged

Proper electriil supply is

Used

Load is overdried

Fabric softener is used

Synthetics, synthetic blends, permanent press and knits are in load

CAUSES/SOLUTIONS

Remove items while there is still a trace of moisture. Some itema should be removed while dsmp. then shaped and air dried.

Some knits are stretched during manufac- turing. Washing and drying returns them to the original size. This is normal. Check quality of garment before buying. Follow fabric care label directions carefully.

Some items hold more moisture than others (cottons more than polyester). They take longer to dry. Full loads take longer to dry than small loads of the same fabric.

A load rinsed in cold water will take slightly longer to dry than a warm one. Cold rinses, however, help save energy and reduce wrinkling more than warm rinses do.

Install dryer in a room where the air tempemture is warmer than 45°F (7%). Cold air increases drying time and may cause wrinkles not to be removed.

Install and exhaust your dryer according to the Installation Instructions provided.

Clean lint screen before or after each use.

Clean if needed.

Properly connect the dryer to a grounded electrical circuit that meets the electrical requirements stated in the Installation Instructions.

Remove items while there is still a trace of moisture.

Use a fabric softener and follow package directions carefully.

Synthetics, synthetic blends, permanent press and knits build up static electricity. Use a fabric softener and be careful not to overdry the load.