3.Remove both plastic caps sideways.
3 Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance.
4. Use special spanner A to remove screw D and the compression spring.
5.Turn sealing cap C upside down as
shown in the illustration.
6. Use sealing cap C to cap the hole.
7.Use special spanner A to remove the
two screws E.
8. Use special spanner A to remove the four screws F.
9. Remove transit bar G.
10. Screw in the four screws F again.
11. Use sealing caps B to cap the two large holes.
Important: Press all sealing caps B (2 items) and C (1 item) in firmly so that they snap into the rear wall.
Where to install
Important! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or ad- verse effect on the perfomance of the machine. Frost damage is not covered under the warranty.
•The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpeted floors or soft floor coverings.
•The surface on which the appliance is to be installed must be clean and dry and free from grease, so that the appliance does not slide.
38