Electrolux EW 1280F manual START/PAUSE button

Page 10

The washing machine has stopped with water in tub, at the end of a programme with NIGHT CYCLE option: this is indicated by a static zero.

The washing machine has completed the programme: this is indicated by a blinking zero. The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by means of the SKIP RESET button.

Important!

The first time you use the washing machine, when you switch it on, it may display a blinking zero. This is due to the fact that the washing machine has performed a washing cycle during the manufacturer’s inspection tests, and this cycle has not been erased after its completion.

Delay start, a time value indicated in hours and selected by means of the relevant button.

The delay time is displayed for 3 seconds, then the duration of the selected programme reappears. After you have pressed the START/PAUSE button, the countdown begins, and the delay time value decreases by one unit every hour.

You can delay the start of every programme by up to 24 hours in one hour intervals selecting the DELAY START button.

An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.

An alarm code indicates a fault in the machine operation (see the relevant chapter on page 23).

9 START/PAUSE button

This button has three functions:

Start: after you have selected the desired programme and options, press this button to start the washing machine. The light above the button will stop flashing and remain lit.

If you have selected a delay time by means of the relevant button, the countdown will begin and will be shown on the display.

Pause: when you press this button again, the programme in progress is interrupted. The light above the button will start flashing. To restart the programme, press the button again.

Important! You must set the washing machine to PAUSE before you make any change in the programme in progress.

Draining of water and spinning after the completion of programmes with the NIGHT CYCLE option.

10

Image 10
Contents Instruction Booklet Contents Child safety General safetyDear customer Tips for environmental protection Technical specificationsDisposal Packaging materialsPositioning InstallationUnpacking Water inletWater drainage Electrical connectionYour new washing machine Use Drain only Options buttonsDisplay Not available for Wool and Hand Wash programmeSTART/PAUSE button Selecting a special programme Skip Reset buttonStart button not pressed Delay Start button Programme phase indicator lightsSorting the laundry TemperaturesLaundry weights Before loading the laundryNot enough washing powder causes Detergents and additivesQuantity of detergent to be used Too much washing powder causesPlace the laundry in the drum Switch the machine onSelect the desired programme/ fabric Measure out the detergentSelect the Spin Speed or the Night Cycle option Select the temperatureSelect the Delay Start Select the desired optionsHow to change a programme during its cycle End of programmeWool Washing ProgrammesHandwash Bleaching Dry cleaningEnergetic wash Delicate wash IroningAfter each wash MaintenanceMaintenance Wash Door sealWater inlet filter Drain pumpEmergency emptying out Page Trouble-Shooting Guide Problem Possible causeNot spun enough Door will not openSpinning starts late or the laundry is No water is visible in the drum0800 10 66 Conditions of the warranty 13 13