Electrolux EW 1280F manual Water drainage, Electrical connection

Page 6

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in four ways:

Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece of string or attaching it to the wall.

P0022

In a sink drain pipe branch. This branch must be above the tap so that the bend is at least 60 cm above the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

Floor drain: the washing machine should be installed where a floor drain or hole is located (depending on plumbing regulations). A floor drain is required to drain away water which may overflow from the washing machine due to a hose leak or malfunction.

The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.

P0023

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre.

Electrical connection

Plug the washing machine into a properly earthed 3 pin power point.

DO NOT USE AN EXTENSION CORD.

CAUTION !

If the appliance is supplied from a cord extension set or an electrical portable outlet device, the cord extension set or electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture.

The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.

IMPORTANT!

If the electrical cord of this appliance is damaged, it must be replaced by the Manufacturer, Authorised Service Agent or similarly qualified person in order to avoid a hazard.

6

Image 6
Contents Instruction Booklet Contents General safety Child safetyDear customer Tips for environmental protection Technical specificationsDisposal Packaging materialsPositioning InstallationUnpacking Water inletWater drainage Electrical connectionYour new washing machine Use Drain only Options buttonsDisplay Not available for Wool and Hand Wash programmeSTART/PAUSE button Skip Reset button Selecting a special programmeStart button not pressed Delay Start button Programme phase indicator lightsSorting the laundry TemperaturesLaundry weights Before loading the laundryNot enough washing powder causes Detergents and additivesQuantity of detergent to be used Too much washing powder causesPlace the laundry in the drum Switch the machine onSelect the desired programme/ fabric Measure out the detergentSelect the Spin Speed or the Night Cycle option Select the temperatureSelect the Delay Start Select the desired optionsHow to change a programme during its cycle End of programmeWashing Programmes WoolHandwash Bleaching Dry cleaningEnergetic wash Delicate wash IroningAfter each wash MaintenanceMaintenance Wash Door sealDrain pump Water inlet filterEmergency emptying out Page Trouble-Shooting Guide Problem Possible causeNot spun enough Door will not openSpinning starts late or the laundry is No water is visible in the drum0800 10 66 Conditions of the warranty 13 13