Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
1.Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.
5.Set the machine upright and remove the remaining rear screw. Slide out the relevant pin.
6.Plug all the holes with the plugs which you will find in the envelope containing the instruction manual.
P1128 | P0002 |
P1129 |
P0001 |
Positioning |
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or cupboard units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any
2.Remove the polystyrene block(s) from the bottom of the machine and release the two plastic bags.
3.Very carefully slide out the left polythene bag, removing it towards the right and then downwards.
unevenness in the floor.
1 |
2 |
3 |
P1123 |
P1126 |
Water inlet
Connect the water inlet hose to a tap with 3/4” BSP thread.
4.Very carefully slide out the right polythene bag, removing it towards the left and then upwards.
Use the hose supplied with the washing machine.
DO NOT USE OLD HOSES.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
P1088 |
P0021 |
5