Problem | Possible cause |
|
|
• The door will not open: | • The programme is still running, the drum is turning. |
| • The door lock has not yet released. |
| • The water level is above the bottom edge of the door. |
| • The machine is heating the water. |
|
|
• Spinning starts late or the laundry is | • The electronic unbalance detection device has cut |
not spun enough: | in because the laundry is not evenly distributed in |
the drum. The laundry is redistributed by reverse | |
| rotation of the drum. This may happen several |
| times before the unbalance disappears and normal |
| spinning can resume. If, after few minutes, the |
| laundry is still not evenly distributed in the drum, |
| the machine will spin at a lower speed or will not |
| spin. If at the end of the programme the laundry is |
| not spun enough, redistribute the load manually |
| and select the spin programme. |
|
|
• No water is visible in the drum | • Machines based on modern technology operate |
| very economically using very little water without |
| affecting performance. |
|
|
• The machine makes an unusual noise | • The machine is fitted with a type of motor which |
| makes an unusual noise compared with other |
| traditional motors. This new motor ensures a softer |
| start and more even distribution of the laundry in |
| the drum when spinning, as well as increased |
| stability of the machine. |
|
|
If you are unable to identify or solve the problem, contact your nearest service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information.
| Mod |
| Prod. No |
P0042 BD | Ser. No |
|
24