Electrolux EW 1280F Skip Reset button, Selecting a special programme, Start button not pressed

Page 11

10 SKIP RESET button

This button performs two functions:

-Clears the memory

-Selects special programmes

At the end of every programme the RESET button must be pressed once or repeatedly to clear the programme memory. This will be confirmed by three dashes, flashing in the display.

If the previous programme is not cleared, the display will show a “0” flashing and an audible signal will sound, when you switch the machine on.

Selecting a special programme:

A wash programme must be selected in the normal way.

(START button not pressed)

Start/Pause

The SKIP button is then used to cancel or advance the programme to the required phase.

The SKIP button can only operate when the programme is in pause. The relevant pilot light blinks.

A normal wash cycle consists of the following phases, Wash - Rinses - Spin and is confirmed by the illumination of the corresponding LED,s.

Prewash

Wash

Rinses

Spin

Drain

To select rinses & spin, the programme must be paused (START/PAUSE button depressed), now press the SKIP button once, the wash LED goes out.

Prewash

Wash

Rinses

Spin

Drain

To select spin only, now press the SKIP button twice.

The wash & rinses LED,s go out.

Prewash

Wash

Rinses

Spin

Drain

To select Drain, now press the SKIP button three times, the wash - rinses - spin LED,s go out and the Drain LED remains lit.

Prewash

Wash

Rinses

Spin

Drain

11

Image 11
Contents Instruction Booklet Contents Dear customer General safetyChild safety Packaging materials Technical specificationsDisposal Tips for environmental protectionWater inlet InstallationUnpacking PositioningElectrical connection Water drainageYour new washing machine Use Not available for Wool and Hand Wash programme Options buttonsDisplay Drain onlySTART/PAUSE button Start button not pressed Skip Reset buttonSelecting a special programme Programme phase indicator lights Delay Start buttonBefore loading the laundry TemperaturesLaundry weights Sorting the laundryToo much washing powder causes Detergents and additivesQuantity of detergent to be used Not enough washing powder causesMeasure out the detergent Switch the machine onSelect the desired programme/ fabric Place the laundry in the drumSelect the desired options Select the temperatureSelect the Delay Start Select the Spin Speed or the Night Cycle optionEnd of programme How to change a programme during its cycleHandwash Washing ProgrammesWool Ironing Dry cleaningEnergetic wash Delicate wash BleachingDoor seal MaintenanceMaintenance Wash After each washEmergency emptying out Drain pumpWater inlet filter Page Problem Possible cause Trouble-Shooting GuideNo water is visible in the drum Door will not openSpinning starts late or the laundry is Not spun enough0800 10 66 13 13 Conditions of the warranty