Electrolux LAVAMAT 62810 manual If the wash result is not satisfactory

Problem	Possible cause	Remedy
Conditioner has not	The softener insert in the
been rinsed in, com-		Clean the detergent drawer,
	compartment for condition-
partment w for condi-	ers has not been correctly	insert the conditioner insert
tioner is filled with		firmly.
	inserted or is blocked.
water.
	The door is locked.	Wait until the DOOR indica-
		tor is illuminated green.
		The programme will continue
The door cannot be		when the power cut has end-
	There has been a power cut.	ed.
opened when the wash-
ing machine is switched	(All the indicators have gone	To remove the washing:
on.	out.)	If water can be seen in the
	The door remains locked for	appliance, prior to opening
	approx. 4 to 10 minutes.
		the door first let the water
		out (see section “Carrying
		out an emergency drain”).
The washing is badly	Perhaps too many items	Observe the maximum load
creased.	were loaded.	volume.

If the wash result is not satisfactory

The washing is grey and there are limescale deposits in the drum

•Too little detergent was used.

•An incorrect detergent was used.

•Individual stains were not pre-treated.

•The programme or temperature was not set properly.

There are grey stains on the washing

•Items that were soiled with ointments, fats or oils were washed using too little detergent.

•The wash temperature used was too low.

•A common cause is that conditioner – in particular the type in con- centrated form - has come in contact with the washing. Wash out such marks as soon as possible and exercise care when using the said conditioner.

Foam can still be seen following the final rinse

•Modern detergents can cause foam to be created even during the fi- nal rinse. In spite of this, the washing has been sufficiently rinsed.

21