Electrolux LAVAMAT 62810 manual Where to install

Page 28

3.Remove both plastic caps sideways.

3 Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance.

4. Use special spanner A to remove screw D and the compression spring.

5.Turn sealing cap C upside down as

shown in the illustration.

6. Use sealing cap C to cap the hole.

7.Use special spanner A to remove the

two screws E.

8. Use special spanner A to remove the four screws F.

9. Remove transit bar G.

10. Screw in the four screws F again.

11. Use sealing caps B to cap the two large holes.

Important: Press all sealing caps B (2 items) and C (1 item) in firmly so that they snap into the rear wall.

Where to install

Important! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or ad- verse effect on the perfomance of the machine. Frost damage is not covered under the warranty.

The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpeted floors or soft floor coverings.

The surface on which the appliance is to be installed must be clean and dry and free from grease, so that the appliance does not slide.

28

Image 28
Contents Lavamat Following symbols are used in the text Dear CustomerContents Installation and connection instructions Safety information concerning installationSafety Prior to using the appliance for the first timeChild safety Follow the Installation and connection instructionsGeneral safety Resulting overheating may constitute a fire hazardDescription of the appliance Control panelProgramme overview RefreshApplication/Features Care Symbols1 Before the first wash Preparing and sorting washingPreparing washing Sorting washingRunning a wash cycle Opening the door/loading washingAdding detergent /conditioner Open the door pull the handle on the doorIf you are using liquid detergent Washing powder/tablets for the main wash cycleSwitching on the appliance/selecting a programme Changing the spin speed/selecting rinse holdSelecting additional programmes Shortened wash programme for lightly soiled itemsStarting a programme Setting the delay timerProgramme sequence Interrupting a programme/adding washing End of the wash cycle/removing the washingInterrupting a programme Adding washingChild safety device Deactivating the child safety deviceCleaning and maintenance Cleaning procedureDetergent dispenser drawer Washing drumRemedying small faults yourself Clean the glass in the door and the rubber collar regularlyWhat to do if Door and rubber collarE10 appears Tap is shut off Turn on the tap END indicator is There are grey stains on the washing If the wash result is not satisfactoryFoam can still be seen following the final rinse Carrying out an emergency drain When the water has all drained awayThere are white residues on the washing Drain pump Packaging material DisposalOld appliance Technical data Consumption valuesSafety information concerning installation This washing machine cannot be built-inInstalling the appliance When using a sack trolley to transport the washing machineTransporting the appliance Removing the transit packagingWhere to install Making the appliance level If the appliance is to stand on a baseElectrical Connection Brown Live Wire coloured green and yellowPermanent Connection Connecting the appliance to the water supply Permitted water pressureWater inlet 35m long pressure hose is supplied with the applianceWater Drainage From your Service Force CentreFor drainage into an outlet Pumping heights of over 1 metre Warranty conditions Great BritainFurther after-sales service agencies overseas Autres agences étrangères assurant le service après-venteWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroCustomer Service Centres Hungary 0870 5 929 Customer CareFor general enquiries concerning Major AppliancesAEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG