Electrolux LAVAMAT 50600 operating instructions Troubleshooting

		Troubleshooting
Fault	Possible cause	Remedy
	The inlet hose connection is	Tighten the inlet hose
	not tight.	connection.
	The inlet hose has a leak.	Check the inlet hose and if
Water is leaking out		necessary replace it.
from under the	The drain pump cover is not	Tighten cover by turning
washing machine.
	tight.	clockwise.
	Washing is caught in the	Abort the program, remove
		the washing caught in the
	door.
		door, start a new program.
Fabric softener is not
added, compartment	Suction cap in the fabric	Clean the detergent
À for fabric	softener compartment is not	compartment, fit the suction
softener is filled with	correctly fitted or is blocked.	cap on firmly.
water.
Appliance does not	RINSE HOLD selected.	Deselect RINSE HOLD.
spin, water in the	SOAKING program is	Pump out water and set the
drum.
	terminated.	main wash cycle as desired.
	There is a kink in the outlet	Eliminate the kink.
	hose.
	Maximum pumping height	Please contact AEG Service
Washing has not been	(drain height 1m from the	Force Centre, it has a retro-
	position of the machine) is	kit available for pump
spun sufficiently, there	exceeded.	heights above 1m.
is water left in the		Switch off the machine and
drum.
	Drain pump is blocked.	pull the plug out of the
		socket, clean the drain pump.
	The water drainage system is	Clean the blockage.
	blocked.
Door cannot be	The door is locked due to	After programm termination
opened.	safety reasons	wait for 2-3 minutes.
The rinse water is	Probably caused by a	This does not affect the
	washing powder with a high	rinse results. If necessary use
cloudy.
	silicate content.	liquid detergent.

29