Electrolux 10500 VI Due to the additional 40 mm height required, ensure, Approximately 5 mm is

100 mm

F

Fig. G

Building-in

If it is not possible to use one solid piece,

due to the additional 40 mm height required, ensure

that any additional strips of timber are

5 mm Hardwood strip

600-605 mm

Additional pieces of timber should run

from front to back

glued and screwed to the underside of the base (see Fig. F).

Drill four fixing holes see Position the base into

the recess with its front edge as far forward as the adjoining plinth line will allow. The rea- son for placing the base in this position is to allow a small strip of beading to be fit- ted in front of the appliance feet.

Front

view

600-605 mm

490 mm

95 mm

50 mm	Front edge
	Top
G	view

Fix the base firmly to the floor using four appropriate countersunk screws

(see Fig. H).

With the appliance	Hardwood strip
installed adjust all four		5 X 25 X 605
	5 mm x 25 mm
		490

feet ensuring the machine	600-605
is stable, and a clearance
	H
of approximately 5 mm is

left between the top of the machine and the underside of the work- top.

A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine adjust- ment to the feet.

A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will provide additional security.

If required an additional door magnet, part number 1242394-00/3 and disc, part number 1242393-00/5 are available from spare parts.

51