Cub Cadet 59A40003727 manual Backblading, Backgrading, Loading Low Trucks or Spreaders from a Pile

Page 21

Loading Low Trucks or Spreaders from a Pile

For easier loading, minimize the angle of turn and length of run between pile and spreader. See Figure 26.

Backblading

Position the bucket at an angle of less than 45º and backup slowly. See Figure 28

Backgrading or backblading with bucket tilted too far will result in damage to tilt cylinders and void warranty. See Figure 28.

Correct

NOT Correct

Figure 26

Backgrading

Backgrade occasionally with a loaded bucket to keep the working surface free of ruts and holes. Also, hold the control lever forward so the full weight of the

bucket is scraping the ground. Use the heel of theFigure 28 bucket. See Figure 27.

Figure 27

Image 21

Contents 769-03185 Operator’s ManualTable of Contents Finding Model NumberCalling Customer Support Training Safe operation practicesMove and turn tractor at low speeds Improper use of a loader can cause injury or deathMaintenance Labels found on loader Model 59A40003727 loader specifications To the Dealer If Using an Overhead Lift Unpacking the loaderIf an Overhead Lift is Not Available Installing the LH and RH Mounts Initial InstallationInstalling the Front Mount Receiver Install the RH and LH mounts as followsFirst installation of Loader on Tractor Using an Overhead Lift For Initial InstallationFront Loader Preparation Mounting the Bucket Hydraulic Out lets Pre-Charging Cylinders for Initial Installation#2-Yellow #3-BlueChecking Implement Control Lever Operation Initial Installation of Loader on TractorStop the tractor engine and engage the parking brake Start the tractor’s engine and operate at a low/safe RPMHose Retainer Rod LH Mast Front Mount Receiver Mounting Pin LH Mount Lynch PinDismounting the Loader Dismounting and mounting the loaderFalling Stored positionMount the loader as follows Mounting the LoaderOperation Lifting the Load Operating the LoaderCarrying the Load Correct Not CorrectDumping the Bucket Lowering the BucketLower Roll Back Operating with a Float Control Surface Material Peeling and ScrapingLoading from a Bank Backblading BackgradingLoading Low Trucks or Spreaders from a Pile Handling Objects BackfillingMaintenance General MaintenanceLubrication Daily Jerky Operation TroubleshootingSlow Operation Oil LeaksBucket or Boom Leaks Control When LeverDown from Hold PositionParts list 710-0376