Cub Cadet 59A40003727 manual Bucket or Boom Leaks, Down from Hold, Position, Cannot Lower Boom

Page 25

PROBLEM		POSSIBLE CAUSE		SOLUTION

Bucket or Boom Leaks	• Leaks in hydraulic circuits		• Tighten loose fittings. Use
Down from “Hold”				thread sealer on pipe threads.
Position	• Cylinder piston seals leaking		• Repair (if available) or replace.
	• Cylinder piston seals leaking		• Repair (if available) or replace.
	• Remote valve worn or damaged		•	Repair.
	• Tractor valve worn or damaged		•	Repair.

Cannot Lower Boom	• Hydraulic couplers not fully engaged.		•	Recouple hoses.

Loss of Bucket Tilt	• Tractor lever in “Float” position		• Shift control lever from “Float”
Control When Lever				position.
is Pushed Completely
Forward

Couplers Hard	•	Pressure in circuit	• Place control levers in “Float”
to Hook Up				when connecting.

Boom & Bucket	• Improperly installed hydraulic couplers		•	Install hydraulic couplers
Operation Does Not				correctly.
Correspond To Control	•	Hoses improperly connected	•	Connect hoses properly.
Lever Position

Excessive Wear on	• Bucket is tilted too far forward and is riding		• Keep bottom of bucket parallel
Bucket Cutting Edge		on cutting edge.		to ground.
and Wear Pads	• Excessive down pressure when cleaning		• Use “Float” position on boom
	• Excessive down pressure when cleaning		• Use “Float” position on boom
		feedlots and working on concrete.		lift control lever.

25

Image 25

Contents 769-03185 Operator’s ManualFinding Model Number Table of ContentsCalling Customer Support Training Safe operation practicesMove and turn tractor at low speeds Improper use of a loader can cause injury or deathMaintenance Labels found on loader Model 59A40003727 loader specifications To the Dealer Unpacking the loader If Using an Overhead LiftIf an Overhead Lift is Not Available Installing the LH and RH Mounts Initial InstallationInstalling the Front Mount Receiver Install the RH and LH mounts as followsUsing an Overhead Lift For Initial Installation First installation of Loader on TractorFront Loader Preparation Mounting the Bucket Hydraulic Out lets Pre-Charging Cylinders for Initial Installation#2-Yellow #3-BlueChecking Implement Control Lever Operation Initial Installation of Loader on TractorStop the tractor engine and engage the parking brake Start the tractor’s engine and operate at a low/safe RPMHose Retainer Rod LH Mast Front Mount Receiver Mounting Pin LH Mount Lynch PinDismounting the Loader Dismounting and mounting the loaderFalling Stored positionMount the loader as follows Mounting the LoaderOperation Lifting the Load Operating the LoaderCarrying the Load Correct Not CorrectLowering the Bucket Dumping the BucketLower Roll Back Surface Material Peeling and Scraping Operating with a Float ControlLoading from a Bank Backgrading BackbladingLoading Low Trucks or Spreaders from a Pile Handling Objects BackfillingGeneral Maintenance MaintenanceLubrication Daily Jerky Operation TroubleshootingSlow Operation Oil LeaksBucket or Boom Leaks Control When LeverDown from Hold PositionParts list 710-0376