Cub Cadet 59A40003727 manual Backfilling, Handling Objects

Page 22

Backfilling

Approach the pile with a flat bucket. Do not use the bucket in the dump position for bulldozing. This method will impose severe shock loadings on the dump linkage, the tilt cylinder, and the tractor. Refer to Figure 29.

•Leave dirt in the bucket because dumping on each pass wastes time.

•Operate at right angles to the ditch. Take as big a bite as the tractor can handle without lugging down.

•Leave dirt which drifts over the side of the bucket for final clean-up.

•Pile dirt on the high side for easier backfilling on a slope.

Correct

NOT Correct

Figure 29

Handling Objects

WARNING: Avoid injury or death from falling objects. This loader is not equipped with any method to prevent objects such as round bales, posts, logs, etc. from rolling back onto opera- tor.

WARNING: Do not carry large objects that can fall out of loader bucket into operator zone.

WARNING: Never lift loader higher than necessary to clear the ground when moving.

Image 22

Contents Operator’s Manual 769-03185Finding Model Number Table of ContentsCalling Customer Support Safe operation practices TrainingImproper use of a loader can cause injury or death Move and turn tractor at low speedsMaintenance Labels found on loader Model 59A40003727 loader specifications To the Dealer Unpacking the loader If Using an Overhead LiftIf an Overhead Lift is Not Available Installing the Front Mount Receiver Initial InstallationInstalling the LH and RH Mounts Install the RH and LH mounts as followsUsing an Overhead Lift For Initial Installation First installation of Loader on TractorFront Loader Preparation Mounting the Bucket #2-Yellow Pre-Charging Cylinders for Initial InstallationHydraulic Out lets #3-BlueStop the tractor engine and engage the parking brake Initial Installation of Loader on TractorChecking Implement Control Lever Operation Start the tractor’s engine and operate at a low/safe RPMLH Mast Front Mount Receiver Mounting Pin LH Mount Lynch Pin Hose Retainer RodFalling Dismounting and mounting the loaderDismounting the Loader Stored positionMounting the Loader Mount the loader as followsOperation Carrying the Load Operating the LoaderLifting the Load Correct Not CorrectLowering the Bucket Dumping the BucketLower Roll Back Surface Material Peeling and Scraping Operating with a Float ControlLoading from a Bank Backgrading BackbladingLoading Low Trucks or Spreaders from a Pile Backfilling Handling ObjectsGeneral Maintenance MaintenanceLubrication Daily Slow Operation TroubleshootingJerky Operation Oil LeaksDown from Hold Control When LeverBucket or Boom Leaks PositionParts list 710-0376