Dyson CRO2 manual Installation, Specification, Location, Drainage, water supply and electricity

Page 8

Installation

5 01

Specification

Dimensions Height 848mm Depth 575mm Width 595mm

Weight: 103kg.

Voltage: 220-240V, 50Hz. Please refer to rating plate (see section 1 01 for location).

Power: 2750W 230V. Please refer to rating plate (see section 1 01 for location).

Water pressure: 0.4-5 bar.

Capacity: 7kg dry laundry maximum.

Location

Every Dyson washing machine is tested before it leaves the factory. As a result, there may be some dampness or water in the machine.

The machine should not be installed in a location where the temperature may drop below freezing.

The machine should not be installed in a bathroom.

The machine must be installed on a secure and flat surface. Soft floors, such as carpet or carpet tiles, are not suitable. The layout of the drainage taps and power socket and their distance from the machine are illustrated below. The water inlet hoses, drainage hose and electrical mains lead must be positioned carefully to avoid damage or kinks when the machine is in use. The machine can be connected to a standpipe, under-sink pipe connection or other drainage system, but the critical dimensions must be adhered to.

Important

595mm

600 mm

450 mm

848 mm

 

MAX.

 

MIN.

 

 

 

600 mm MAX.

450 mm MIN.

Drainage using an under-sink pipe*

Drainage, water supply and electricity

The washing machine comes with:

2 inlet hoses

1 drainage hose hook

1 Dyson spanner

1 drainage hose at the back of the machine

Cold inlet hose

Dyson spanner

Hot inlet hose

Drainage hose hook

Note: Hoses can be supplied in 2.5m lengths if required. Please contact the helpline to order.

The above items are found in the drum unless stated otherwise.

Drainage using a stand pipe*

Image 8
Contents User guide Page Contents Overview Overview of your Dyson washing machineContrarotatorTM Only 2-drum wash actionFree registration Important safety notes Dyson serviceUser Instructions Do notBefore installation Inner transit packaging removalInstallation SpecificationLocation Drainage, water supply and electricityDrainage Water supply Do not use the hose hook for under-sink connectionsElectrical installation After installationOperation Loading the washing machine Detergent useStarting your wash Cancel your wash cycle End of wash cycleStart your wash cycle Pause your wash cycleOptional settings Child lock Additional optionsMemory Door lock Fabric care and advice 9 Programme table Maintenance Self clean cycle on selected models onlyCoin trap Always wash hands after handling the coin trapWater filter Emergency door releaseTroubleshooting Troubleshooting Symptom Possible causes SolutionsLCD display message Possible causes Solutions SectionN U I N E C O M P O N E N T S