Installation | 5 02 |
Drainage | Water supply |
You can alter the direction of the drainage hose to the left or right.
•To change the direction of the machine’s drainage hose, squeeze open the retaining clip using a pair of pliers and hold it open while you rotate the hose.
•Ensure the hose is inserted properly before releasing the clip.
•Thread the drainage hose through the hose hook and adjust the protruding end to a distance of 30mm. The hose hook has a small retention hole that can be used to secure the hose in position.
Do not use the hose hook for under-sink connections.
30mm | Drainage hose hook | |
Drainage hose | ||
| ||
Stand pipe |
|
When installed with a standpipe or
NB: Failure to comply with these dimensions could cause the machine to malfunction.
•Connect your machine to the water supply by hand, using the hoses supplied. Only tighten by hand, do not use a spanner. Do not use old hoses.
• Ensure the water pressure is between 0.4 and 5 bar.
Do not:
• connect the machine to a mixer tap.
Hot and cold water supply
•Attach the blue inlet hose to the cold inlet tap and the red hose to the hot inlet tap, and turn on water supply.
*Note: CRO1 Flowcheck and Memory have grey leak protection inlet hoses