■Use clamps to seal all joints. Exhaust vent must not be connected or secured with screws or other fastening devices which extend into the interior of the duct. Do not use duct tape.
IMPORTANT: Observe all governing codes and ordinances.
Improper venting can cause moisture and lint to collect indoors, which may result in:
Moisture damage to woodwork, furniture, paint, wall- paper, carpets, etc.
Housecleaning problems and health problems.
Use a heavy metal vent. Do not use plastic or metal foil vent.
Rigid metal vent is recommended to prevent crushing and kinking.
Flexible metal vent must be fully extended and supported when the dryer is in its final position. Remove excess flexible metal vent to avoid sagging and kinking that can result in reduced airflow and poor performance.
An exhaust hood should cap the vent to prevent rodents and insects from entering the home.
Exhaust hood must be at least 12 in. (30.5 cm) from the ground or any object that is in the path of the exhaust (such as flowers, rocks or bushes, etc.).
If using an existing vent system, clean lint from the entire length of the system and make sure exhaust hood is not plugged with lint. Replace any plastic or metal foil vent with rigid metal or flexible metal vent.
Plan Vent System
Typical exhaust installations
Typical installations vent the dryer from the rear of the dryer. Other installations are possible.
| 2 |
| 3 |
| 4 |
1 | 5 |
| 6 |
| 7 |
| 8 |
1.Dryer
2.Elbow
3.Wall
4.Exhaust hood
5.Clamps
6.Rigid metal or flexible metal vent
7.Vent length necessary to connect elbows
8.Exhaust outlet
Optional exhaust installations
This dryer can be converted to exhaust out the right side, left side, or through the bottom. Contact your local dealer to have the dryer converted.
Fire Hazard
Cover unused exhaust holes with one of the following kits:
279818 (white)
279925 (biscuit)
279969 (pewter)
Contact your local dealer.
Failure to follow these instructions can result in death, fire, electrical shock, or serious injury.
1 | 2 | 3 |
1.Standard rear offset exhaust installation
2.Left or right side exhaust installation
3.Bottom exhaust installation (Not an option with pedestal installations.)
Alternate installations for close clearances
Venting systems come in many varieties. Select the type best for your installation. Two
12
1.Over the top installation (also available with one offset elbow)
2.Periscope installation
12