Miele W 1113 operating instructions General issues with the washer

Page 36

Frequently asked questions

 

 

 

 

 

 

 

General issues with the washer

 

 

 

 

Issue

Possible cause

Solution

The "Oversudsing"

The machine has over

Use less detergent in the

indicator lights.

sudsed.

next wash program.

The "Main wash"

There is a fault.

Restart the program.

indicator flashes.

 

If the fault message appears

 

 

again, call Miele’s Technical

 

 

Service Department.

The washer shakes

The washer’s four feet

Level the machine (see

during the spin cycle.

are not resting evenly

Installation Instructions).

 

on the floor.

 

There are unusual

There is no fault. Lapping sounds at the beginning

sounds coming from the

and end of the pump process are normal.

drain pump.

 

 

A large amount of

The water pressure is

– Clean the water intake

detergent residue

too low.

hose filter under running

remains in the

 

water and carefully

dispenser drawer.

 

remove any large

 

 

particles.

 

 

– Select the "Sensitive"

 

 

button.

The fabric softener is

The siphon tube is

Clean the siphon tube (see

not completely

incorrectly positioned

"Cleaning and care-

dispensed, or too much

or clogged.

Cleaning the detergent

water remains in the

 

dispenser drawer").

fabric softener

 

 

compartment §.

 

 

32

Image 36
Contents Operating instructions Washer 1113 Contents Contents Important Safety Instructions Guide to the washer Control panelBefore using for the first time Using the washer Prepare and sort the laundryGeneral tips Load the laundry Select a program Close the drum doorProgram guide Temperatures Fabric Spin Laundry Care Speed Symbol Woolens Cold MedSilk HandwashSelect wash options if needed Select the temperature and spin speed Special spin options Hold No spinTo start the final spin To finish the programAdd detergent Too little detergent may causeToo much detergent may cause Detergent Liquid detergent insertWater hardness Water softenerNormal soiling Heavy soilingFabric softener Starch Do not exceed the maximum fill levelSelect Delay Start if needed Canceling Delay StartStart the program Activate the program lock if necessaryRemove the laundry Canceling a program Making changes to the programInterrupting a program Adding / removing laundry during a wash program Drum door cannot be opened ifLocking the washer Electronic program lockCleaning the washer Cleaning the drumWasher care Cleaning the detergent drawer Cleaning the drain pump and lint trap Open the access panelQuick Guide Remove this guide for easy referenceQuick Guide Sort the laundryLoad the laundry Select a programSelect the temperature and spin speed Select Delay Start if neededAdd detergent Start the programNormal Options Washer care Cleaning the water inlet filters Cleaning the inlet hose filterCleaning the filter in the inlet valve Changing the light bulb Frequently asked questions Wash program cannot be startedProgram was interrupted and a fault message appears General issues with the washer Poor wash results Door will not open when the Door button is pressed Opening the drum door during a power failure Remove the toolTechnical Service PC UpdateOptional accessories RepairsInstallation Instructions Help protect our environment Disposal of the packing materialDisposal of an appliance Installation Front viewBack view Installation site Installation Remove the shipping strutsDo not lift the washer by the drum door Installation Pull out the shipping strutInstalling the shipping struts Adjust the four leveling feet Level the washerInstallation beneath a counter Washer stand with drawer Reinstallation of the machine lid Washer / Dryer StackHose extension optional accessory PlumbingWater connection Do not connect the washer to hot water onlyTips for a hot water connection Drainage Electrical connection Grounding InstructionsAlterations rights reserved / 2106 / with det insert
Related manuals
Manual 56 pages 23.56 Kb