Miele W 1113 operating instructions Plumbing, Hose extension optional accessory

Page 52

Plumbing

The washing machine can be connected to a portable water supply. A non-return valve is not needed unless required by building code.

The washing machine has ½" (13 mm) pressure hoses with ¾" (19 mm) female hose thread connections. If there is no water hookup, contact a plumber to install a connection. Make sure that the sealing ring is seated properly on the hose connector.

Replace the hose only with a genuine Miele hose, or with a hose able to withstand up to 145 psi (10 bar) pressure. The water valve connector must also be able to withstand 145 psi (10 bar).

,The bolted connection is under water pressure. Open the water supply slowly to check for leaks. Adjust the rubber seal and the bolted connection if necessary.

To protect the inlet valve, the two filters (one at the pressure hose / valve connection and one at the inlet connection to the solenoid valve) must not be removed.

Hose extension (optional accessory)

Hose extensions with a length of

8’ 2 7/16" to 13’ 1 1/2" (2.5 to 4 m) are available from your Miele dealer or

Miele.

48

Image 52

Contents Operating instructions Washer 1113 Contents Contents Important Safety Instructions Guide to the washer Control panelBefore using for the first time Prepare and sort the laundry Using the washerGeneral tips Load the laundry Select a program Close the drum doorProgram guide Temperatures Fabric Spin Laundry Care Speed Symbol Woolens Cold MedSilk HandwashSelect wash options if needed Select the temperature and spin speed Special spin options Hold No spinTo start the final spin To finish the programToo little detergent may cause Add detergentToo much detergent may cause Detergent Liquid detergent insertWater hardness Water softenerNormal soiling Heavy soilingFabric softener Starch Do not exceed the maximum fill levelSelect Delay Start if needed Canceling Delay StartStart the program Activate the program lock if necessaryRemove the laundry Making changes to the program Canceling a programInterrupting a program Adding / removing laundry during a wash program Drum door cannot be opened ifLocking the washer Electronic program lockCleaning the drum Cleaning the washerWasher care Cleaning the detergent drawer Cleaning the drain pump and lint trap Open the access panelQuick Guide Remove this guide for easy referenceQuick Guide Sort the laundryLoad the laundry Select a programSelect the temperature and spin speed Select Delay Start if neededAdd detergent Start the programNormal Options Washer care Cleaning the inlet hose filter Cleaning the water inlet filtersCleaning the filter in the inlet valve Changing the light bulb Frequently asked questions Wash program cannot be startedProgram was interrupted and a fault message appears General issues with the washer Poor wash results Door will not open when the Door button is pressed Opening the drum door during a power failure Remove the toolTechnical Service PC UpdateOptional accessories RepairsInstallation Instructions Disposal of the packing material Help protect our environmentDisposal of an appliance Installation Front viewBack view Installation site Remove the shipping struts InstallationDo not lift the washer by the drum door Installation Pull out the shipping strutInstalling the shipping struts Adjust the four leveling feet Level the washerInstallation beneath a counter Washer stand with drawer Reinstallation of the machine lid Washer / Dryer StackHose extension optional accessory PlumbingDo not connect the washer to hot water only Water connectionTips for a hot water connection Drainage Electrical connection Grounding InstructionsAlterations rights reserved / 2106 / with det insert

Related manuals

Manual 56 pages 23.56 Kb