Problem solving guide
Any work on the electrical compo- nents of this appliance should only be performed by a qualified and trained person in accordance with all local and national codes and regulations. Unauthorized repairs may cause injury and damage to the machine.
The following are minor faults that can be corrected without contacting the Ser- vice Department.
A selected programme does not begin
The “On” indicator lamp does not light up.
Check that
the door is properly closed,
the machine is plugged in and that the fuse or circuit breaker has not tripped.
The “On” indicator lamp is on, a pro- gramme has been selected, but the
The programme selector switch was not at the “Start/Finish” position when the programme was selected. The fol- lowing selection sequence is important:
1.Turn the programme selector switch to
“Start/Finish”.
2.Select a programme.
Check q warning lamp flashes
Drainage fault
Check if the lint trap is clogged. Clean the trap and pump impeller as described on page 25, if necessary. Check whether the drain hose is kinked or clogged.
The check lamp will go out when the programme selector switch is turned to the “Start/Finish” position.
The “End” indicator lamp is on, but the laundry in the machine has not been washed.
The water valve is not open:
Turn the programme selector to “Start/Finish”.
Turn on the water supply valve.
Select a programme.
The water inlet system is blocked: The valve is not fully open.
The inlet hose is kinked or clogged.
The water pressure is too low.
Check if the water flow through the valve is at least 5 l (1 gal.) in 15 seconds.
The filters in the inlet hose are clogged (see “Cleaning and Care” on page 26).
If, after checking the above, too little or no water is taken in during the next pro- gramme, call the Miele Service Depart- ment.
29