Top Innovations SF-407 warranty Filling Water Tank and Water Reservoir

Page 10

USING THE FABRIC STEAMER

FILLING WATER TANK AND WATER RESERVOIR

IMPORTANT: Always make sure that Lighted On/Off Switch is set to “Off” position and unit is unplugged before attempting to fill Water Tank

1.Remove Water Tank from main unit.

2.Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counter-clockwise direction (FIGURE 10).

3.Fill Water Tank with water through Valve Cap Hole. Refer to guidelines on left side of Water Tank to fill it with correct amount of water, depending on desired steam time (15, 30, or 45 minutes). Do not exceed 45 MIN (40 oz.) mark.

NOTE: To prolong life of unit, it is recommended that you use distilled or de- mineralized water in Water Tank. Do not attempt to substitute another water tank for the one designed for use with this unit.

4.Replace Valve Cap by rotating it in a clockwise direction.

5.Place Water Tank back onto main unit (FIGURE 11). The sound of water flowing from Water Tank into Water Reservoir should be audible for a short period of time.

IMPORTANT: Do not attempt to operate Fabric Steamer with an empty Water Tank, as doing so could result in damage to the unit.

FIGURE 10

FIGURE 11

10

Top Innovations, Inc.

Image 10
Contents Fabric Steamer Letter from the CEO Important Safeguards Important Safeguards Fabric Steamer Product Information Replacing Accessories Assembling the Telescopic Pole Attaching the Telescopic Pole Attaching the Fabric BrushAttaching the Steam Hose Filling Water Tank and Water Reservoir Operating the Fabric Steamer Tips for Using the Fabric Steamer Steaming GarmentsProper Storage Removing Mineral BUILD-UPProblem Possible Cause Solution Customer SupportONE Year Limited Warranty Top Innovations, Inc Product Serial Number