ASSEMBLING THE FABRIC STEAMER
ATTACHING THE TELESCOPIC POLE
1.Loosen Pole Base by turning it in a
2.Insert bottom section of Telescopic Pole into Pole Base (FIGURE 4).
3.Tighten Pole Base by turning it in a clockwise direction until it is tight, and Telescopic Pole sits firmly in place (FIGURE 5).
FIGURE 4 | FIGURE 5 |
ATTACHING THE FABRIC BRUSH
1.Make sure Lighted On/Off Switch is set to “Off” position, and that the unit is not emitting any steam. Do not try to connect Fabric Brush while unit is emitting steam, as this can cause burns and injury.
2.Align the four pegs on back of Fabric Brush (2 circular and 2 elongated) with corresponding holes on face of Steam Nozzle.
3.Press Fabric Brush firmly onto Steam Nozzle, until it fits snugly and firmly in place (FIGURE 6).
FIGURE 6
8 | Top Innovations, Inc. |