AEG 50212 Running a washing cycle, Opening the door/Loading the washing, For USA and Canada only

Page 11

Running a washing cycle

Opening the door/Loading the washing

1.To open the door: pull the door’s handle.

When the appliance is switched on, the K (DOOR) and (START/ PAUSE) indicators show whether the door can be opened:

K (DOOR) indicator

(START/PAUSE)

Can the door be opened?

indicator

 

 

flashing

flashing

yes, after approx.

2 minutes

 

 

illuminated

illuminated

no, water level and/or

temperature too high

 

 

off

flashing

yes

 

 

 

2. Separate individual items and load washing loosely into the machine. Mix large and small items.

Important: Do not allow items of clothing to get caught between the door and the rubber seal.

3.Press the door firmly shut. The catch must audibly latch.

Adding detergent/additives

Warning! Use only detergents and additives that are suitable for use in domestic washing machines.

1For USA and Canada only!

Important! Only LOW-SUDSING detergent suitable for a front-loading washing machine can be used in this machine. This machine can heat the water up to 95 degrees celsius, or 200 degrees fahrenheit, and care should be taken to ensure that the correct washing powder is used. If you have any doubt, check with your dealer or the distributor.

WARRANTY AND CONSEQUENTIAL DAMAGES ARE VOIDED IF A LOW SUDSING DETERGENT IS NOT USED.

Dose detergent and additives according to the instructions of the de- tergent and additive manufacturers. Follow the advice on the packag- ing.

11

Image 11
Contents Lavamat 50212/50612 Dear customer Following symbols are used in the textContents Installation and connection instructions Follow the Instructions for installation and connection SafetyPrior to using for the first time Child safetyThis could constitute a fire hazard through overheating General safetyControl Panel Description of the applianceProgramme Programme overviewApplication/Features Care Sorting washing Before the first washPreparing and sorting washing Preparing washingFor USA and Canada only Running a washing cycleOpening the door/Loading the washing Adding detergent/additivesIf you use liquid detergents Washing powder/tablets for the main washChanging the spin speed/Selecting rinse hold Switching on the appliance/selecting a programmeDeactivating RINSE+ Selecting programme optionsActivating/deactivating RINSE+ Activating RINSE+Interrupting a programme Setting the delay timerStarting a programme Interrupting a programme/adding washingIf Rinse Hold was selected End of the wash programme/Removing the washingReleasing the child safety device Child safety deviceCleaning and maintenance Cleaning procedureDoor and rubber collar Detergent dispenser drawerWashing drum Remedying minor malfunctions yourself What to do ifOnly a few large items After the last rinse foam can still be seen If the wash results are not satisfactoryWashing is grey and scale is being deposited in the drum There are grey stains on the washingCarrying out an emergency drain When the water has all drained awayDrain pump Old appliance DisposalPackaging material Consumption values Technical dataTransporting the appliance Safety information for the installationInstalling the appliance Unpacking When moving using a sack trolleyPage Where to install Permitted water pressure Connecting to the water supplyElectrical connection Making the appliance levelOpen the porthole and extract the inlet hose Aqua ControlDraining water into a wash basin/bath Water drainagePumping heights over 1 m Guarantee/Customer Service Service & Repair User Instructions & Installation ManualService 132 975 Subject to change without notice