AEG 50612, 50212 Water drainage, Pumping heights over 1 m, Draining water into a wash basin/bath

Page 32

Water drainage

The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. Only original hoses may be used to extend hoses. (A maximum of 3 m laid on the floor and then 80 cm vertically). The Customer Care Depart- ment stocks outlet hoses of different lengths.

Draining water into a sink outlet Secure the outlet/sink outlet joint with a hose band clip (available from your dealer).

Draining water into a wash basin/bath

1Important!

– Small basins are not suitable. Wa-

ter may overflow.

– The end of the drain hose must not be in the water that has been pumped out. Otherwise water could be sucked back into the ap- pliance.

When draining into a wash basin

or a bath, secure the drain hose with the supplied elbow to stop it slipping. Otherwise the water run- ning out can force the hose out of the basin.

– When pumping the water out, check that the water is running away fast enough.

Pumping heights over 1 m

The washing machine’s drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. Warning! If pumping height is over 1 metre, malfunctions and damage to the appliance may arise.

For pumping heights over 1metre a conversion kit can be obtained. Please contact the Customer Care Department.

32

Image 32
Contents Lavamat 50212/50612 Following symbols are used in the text Dear customerContents Installation and connection instructions Safety Prior to using for the first timeChild safety Follow the Instructions for installation and connectionGeneral safety This could constitute a fire hazard through overheatingDescription of the appliance Control PanelProgramme overview ProgrammeApplication/Features Care Before the first wash Preparing and sorting washingPreparing washing Sorting washingRunning a washing cycle Opening the door/Loading the washingAdding detergent/additives For USA and Canada onlyWashing powder/tablets for the main wash If you use liquid detergentsSwitching on the appliance/selecting a programme Changing the spin speed/Selecting rinse holdSelecting programme options Activating/deactivating RINSE+Activating RINSE+ Deactivating RINSE+Setting the delay timer Starting a programmeInterrupting a programme/adding washing Interrupting a programmeEnd of the wash programme/Removing the washing If Rinse Hold was selectedChild safety device Cleaning and maintenanceCleaning procedure Releasing the child safety deviceDoor and rubber collar Detergent dispenser drawerWashing drum What to do if Remedying minor malfunctions yourselfOnly a few large items If the wash results are not satisfactory Washing is grey and scale is being deposited in the drumThere are grey stains on the washing After the last rinse foam can still be seenWhen the water has all drained away Carrying out an emergency drainDrain pump Old appliance DisposalPackaging material Technical data Consumption valuesTransporting the appliance Safety information for the installationInstalling the appliance When moving using a sack trolley UnpackingPage Where to install Connecting to the water supply Electrical connectionMaking the appliance level Permitted water pressureAqua Control Open the porthole and extract the inlet hoseDraining water into a wash basin/bath Water drainagePumping heights over 1 m Guarantee/Customer Service User Instructions & Installation Manual Service & RepairService 132 975 Subject to change without notice